1 - 2 - 3 - 6 - 7 - 8 - A - B - C - D - E - F - G - H - I - K - L - M - N - O - P - Q - R - S - T - U - V - W
Layer
Click on the red underlined text to get to the source
... provide well defined failover behavior, Diameter supports
application-layer acknowledgements, and defines failover
algorithms and the associated state machine ...
... security
[RADIUS] defines an application-layer authentication and integrity
scheme that is required only for use with Response packets. While
...
... message routing (Sections 2.7
and 6), auditability [AAACMS], and transmission-layer security
(Section 13) features, Diameter ...
... Transport Profile document [AAATRANS] discusses transport layer
issues that arise with AAA protocols and recommendations on how to
...
... Diameter messages. A session is a logical
concept at the application layer, and is shared between an access
device and a server, and is identified via the Session-Id AVP ...
... DIAMETER_NO_COMMON_APPLICATION, and SHOULD disconnect the transport
layer connection. Note that receiving a CER ...
... Request message is used by a Diameter node to
inform its peer of its intent to disconnect the transport layer, and
that the peer shouldn't reconnect unless it has a valid reason to do
...
... local resources are freed.
Error The transport layer connection is disconnected, either
politely or abortively, in response to an error
condition ...
... Snd-DPA A DPA message is sent to the peer.
Disc The transport layer connection is disconnected, and
local resources are freed.
...
... <optional value> is implementation specific but may include a modem's
device Id, a layer 2 address, timestamp, etc.
...
... created, or it could be handled using another protocol.
Note, however, that even if at the Diameter layer accounting requests
are processed one by one, transport protocols ...
... Jungmaier, A., Rescorla, E. and M. Tuexen, "Transport Layer Security over Stream Control Transmission Protocol", RFC 3436prop, December 2002. ...
... agent after sending of a record from non-
volatile memory, but prior to receipt of an application layer ACK
and deletion of the record. record to be sent. This will result
...
... - Implementation problems and misconfiguration.
The T flag is used as an indication of an application layer
retransmission event, e.g., due to failover to an alternate server.
...