test message
Click on the red underlined text to get to the source
... In [RFC4204], a link verification procedure is defined whereby Test
messages are transmitted in-band over the data links. This is used
...
... encoding type, and transport mechanisms for
the Test Messages. If the remote node receives a BeginVerify message
...
... and is ready to begin the procedure, it sends a BeginVerifyAck
message specifying the desired transport mechanism for the Test
messages. The remote node also assigns a Verify_Id to the procedure
and includes it in the BeginVerifyAck message ...
... The transmission rate of the data link over which the Test Messages
will be transmitted is represented in IEEE floating-point ...
... G.707].
The Test Message is not transmitted using the J0 bytes
(i.e., over the data link), but is sent over the control
channel ...
... In order to get the mapping between the Interface_Id
over which the J0 Test Message is sent and the J0
pattern sent in-band, the transmitting ...
... transmitting node must provide
the correlation between this pattern and the J0 Test
Message. This correlation is done using the TRACE
object as defined in Section 4.
...
... object as defined in Section 4.
The format of the Test Message is as follows:
<Test Message ...
... node must provide
the correlation between this pattern and the J1 Test
Message. This correlation is done using the TRACE
object as defined in Section 4.
...
... object as defined in Section 4.
The Test Message format is identical to that defined
above in J0-trace.
...
... G.707].
The Test Message is not transmitted using the J2 bytes
(i.e., over the data link), but is sent over the control
channel ...
... In order to get the mapping between the Interface_Id
over which the J2 Test Message is sent and the J2
pattern sent in-band, the transmitting ...
... transmitting node must provide
the correlation between this pattern and the J2 Test
Message. This correlation is done using the TRACE
object as defined in Section 4.
...
... object as defined in Section 4.
The Test Message format is identical to that defined
above in J0-trace.
...