1 - 3 - 4 - 7 - 8 - A - B - C - D - E - F - G - H - I - L - M - N - O - P - Q - R - S - T - U - V - W
Signaling
Click on the red underlined text to get to the source
... There is a need for Switched Circuit Network (SCN) signaling protocol
delivery from an ISDN Signaling Gateway ...
... signaling protocol
delivery from an ISDN Signaling Gateway (SG) to a Media Gateway
Controller (MGC ...
... and point-to-multipoint modes of communication. This support
includes Facility Associated Signaling (FAS), Non-Facility Associated
Signaling (NFAS ...
... includes Facility Associated Signaling (FAS), Non-Facility Associated
Signaling (NFAS), and NFAS with backup D channel ...
... call processing for D channels terminated by
the Signaling Gateways. Practically speaking, an AS is modeled at
...
... physical interface at the SG for which the signaling messages are
sent/received. The format of the Interface Identifier parameter can
...
... architecture that has been defined [5] for SCN signaling
transport over IP uses multiple components, including an IP ...
... transport over IP uses multiple components, including an IP transport
protocol, a signaling common transport protocol, and an adaptation
module to support the services ...
... module to support the services expected by a particular SCN signaling
protocol from its underlying protocol layer.
...
... Signaling Gateway (SG), it is expected that the ISDN signaling
is received over a standard ISDN network ...
... Transport, in order to transport the Q.931 signaling messages to the
MGC where the peer Q.931 ...
... Stream Control
Transmission Protocol (SCTP) as the underlying reliable common
signaling transport protocol. The use of SCTP provides the following
...
... Interface Identifier to a
physical interface on the Signaling Gateway. A physical interface
would be a T1 ...
... overall performance and reliability of the signaling elements. It is
recommended that a separate SCTP stream is used for each D channel ...
... Interface Identifier
identifies the physical interface terminating the signaling channel
at the SG ...
... channel
at the SG for which the signaling messages are sent/received. The
format of the Interface Identifier parameter can be text or integer ...
... The Establish Messages are used to establish a data link on the
signaling channel or to confirm that a data link on the signaling ...
... signaling channel or to confirm that a data link on the signaling
channel has been established. The MGC ...
... Release Request message is used to release the data link on the
signaling channel. The Release Confirm and Indication messages are
used to indicate that the data link ...
... channel. The Release Confirm and Indication messages are
used to indicate that the data link on the signaling channel has been
released.
...
... MGC can consider the data link as being released. In this case,
signaling traffic on that D channel is not expected from the SG ...
... D channel is not expected from the SG and
signaling traffic will not be sent to the SG for that D channel ...
... far end to establish a data link on the
signaling channel (i.e., if SABME is
received, send a DM ...
... terminal (via
the IUA Establish message) for signaling if the ASP wants to be in
control of data link ...
... Layer Management at the ASP can prepare for
send/receive signaling to/from a given TEI and confirm/verify the
establishment of a datalink to that TEI ...
... ASP can check to see whether it was assigned or whether there was an
error in the signaling message. Also, knowing that a TEI is out of
service ...
... unavailable. Transmission of Heartbeat messages is stopped and the
signaling process SHOULD attempt to re-establish communication if it
is configured as the client for the disconnected IUA ...
... message flows for establishing a data link on a
signaling channel, passing PDUs and releasing a data link ...
... message flows for a failed attempt to establish a
data link on the signaling channel is shown below. In this case, the
gateway ...
... ITU-T Recommendation Q.920, 'Digital Subscriber signaling System No. 1 (DSS1) - ISDN User-Network Interface Data Link Layer ...
... Loughney, J., Tuexen, M., and J. Pastor-Balbas, "Security Considerations for Signaling Transport (SIGTRAN) Protocols", RFC 3788prop ...
... Ong, L., Rytina, I., Garcia, M., Schwarzbauer, H., Coene, L., Lin, H., Juhasz, I., Holdrege, M., and C. Sharp, "Framework Architecture for Signaling Transport", RFC 2719, October 1999. ...
... A.1. Signaling Network Architecture ...
... networks does
allow for a sufficiently reliable transport of signaling traffic over
IP. The IUA ...